Valor VENTANA 1200EAN Installation & Operating Instructions Manual page 38

Temperature
Use this setting when you come in and want to enjoy a set temperature.
1. Select either the ☼
temp
2. Hold the SET button until the TEMP display flashes.
3. Set the desired temperature with the
Note: 4.5°C/40°F is the minimum temperature setting.
4. Press the OFF button or simply wait and the display will go to the temperature control mode.
Note: If you would like the Nighttime Setback temperature control to turn off, decrease the
☽
MODE setting until [---] appears on the display.
temp
Your fireplace will reach the set temperatures and the remote handset will check the
temperature every five minutes, adjusting the amount of fuel needed to give you a steady,
even heat.
5. The display must remain in TEMP mode on the remote handset.
Timer
It is possible to program two periods of time per day at which your fireplace will turn on and off
automatically.
For example, you can set your fireplace to turn on in the morning just before you get up (P1
[ ])
start time and to turn off when you leave for the day
fireplace to turn on again at the end of the day (P2
bed at night (P2 ☽ [stop time]).
If you wish to set only one time period at which your fireplace will turn on and off, program P2
[ ] and P2 ☽ [stop time] for the same time as P1 ☽ [stop time].
start time
1. Select TIMER mode by briefly pressing the SET button.
2. Press and hold the SET button until TIMER is displayed on the lower right hand side.
3. Press and hold the SET button until P1 ☼ and the time display flashes. Set the start time by
pressing the button for the hour and the
P1 ☽ and set the stop time in the same manner you just set P1 ☼.
4. Briefly press the SET button again for the next burner cycle time, which will be P2
5. Once all four times are set, press OFF or simply wait to complete programming.
6. The remote handset must remain in TIMER mode to function automatically.
Low Battery Indication
Remote handset: BATT will appear on the display when the battery needs to be replaced.
Replace with one 9 V battery (alkaline recommended).
Receiver: Three short 'beeps' will sound when the motor turns when the batteries need to be replaced. Replace with four
1.5 V batteries (alkaline recommended).
NOTE: With very low battery, the valve shuts off the fire completely. This does not happen when the power supply is
interrupted.
Handset / Receiver Match
The remote control handset and receiver are programmed to function together. In case of a replacement of the handset or
the receiver, you will need to reset the receiver to allow them to function together. Contact your dealer for details
Automatic Standby Mode (when in Temp or Timer modes only)
If there is no transmission from the handset to the receiver within a 6-hour period, the appliance will go to STANDBY
(pilot) mode.
38
Remote Control Operation
MODE or the ☽
MODE by briefly pressing the SET button.
temp
or the buttons.
☼ [
button for the minutes. Then, briefly press SET to
(
P1 ☽ [stop time]). Then, you can set your
])
start time and to turn off when you go to
☼
☼
☼ and
P2 ☽.