Table of Contents
Advertisement
INSTALLATION
Continued
12. Locate thermostatic switch/cover plate as-
sembly and wire harness supplied with blower.
Attach wire harness terminals to terminals on
thermostatic switch. Push firmly. Make sure
the bottom hole of cover is on the opposite
side from the wire harness (see Figure 20).
13. Feed terminal ends of wire harness into the
hole in firebox back panel from front of fire-
box. Pull the ends of the harness to the top of
firebox near blower (see Figure 21).
14. Align holes in the switch/cover assembly with
holes in firebox back panel. Using 3 screws
from step 11, attach assembly to firebox back
panel. Tighten screws firmly (see Figure 21).
15. Working from the rear of the stove, place
entire power cord, including speed control
housing, in lower control compartment (see
Figure 22).
16. Route ends of 3-wire power cord up from the
lower control compartment through the plastic
bushing, then up to the upper cavity of stove
(see Figure 22).
Thermostatic
Switch Mounted
to Cover
Wire Harness
Figure 20 - Attaching Wire Harness to
Thermostatic Switch and Cover Assembly
Thermostatic
Switch
Mounted to
Cover
Screws
Figure 21 - Assembling Thermostatic
Switch and Cover to Firebox Back Panel
111417-01B
Bottom Hole
Wire Harness
Hole in
Firebox
Back
Panel
Wire
Harness
www.desatech.com
17. Connect white wire from speed control to
either terminal on blower motor (see Figure
22). Push firmly.
18. Connect the black wire from speed control
to blue wire on switch/cover assembly (see
Figure 22).
19. Connect red wire from switch/cover assembly
to remaining terminal on blower motor (see
Figure 22). Push firmly.
20. Attach green wire from speed control to front
tab of blower housing using screw provided
(see Figure 22). Tighten securely.
21. Using the four screws previously removed,
mount blower assembly to stove by reattach-
ing blower brackets to rear panel (see Figure
16, page 13). Tighten screws securely.
15
Advertisement
Table of Contents
