1. Manuals
  2. Brands
  3. Comfort Glow Manuals
  4. Stove
  5. S26NT
  6. Owner's operation and installation manual

Comfort Glow S26NT Owner's Operation And Installation Manual

Comfort glow s26nt vent-free natural gas freestanding pedestal stove system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
VENT-FREE NATURAL GAS
FREESTANDING PEDESTAL STOVE SYSTEM
OWNER'S OPERATION AND INSTALLATION MANUAL
S26NT
20,000 to 26,000 Btu/Hr
Thermostatically
Controlled
WARNING: If the information in this manual is not
followed exactly, a fire or explosion may result caus-
ing property damage, personal injury, or loss of life.
— Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
— Installation and service must be performed
by a qualified installer, service agency, or the
gas supplier.
This appliance may be installed in an aftermarket* manufactured (mobile) home, where not prohib-
ited by state or local codes.
*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer. (I.E. Installation of this product is
permitted after the manufactured (mobile) home is sited)
Save this manual for future reference.
®
Patent Pending
WARNING: Improper installa-
tion, adjustment, alteration, ser-
vice, or maintenance can cause
injury or property damage. Re-
fer to this manual for correct
installation and operational pro-
cedures. For assistance or ad-
ditional information consult a
qualified installer, service
agency, or the gas supplier.
WARNING: This is an unvented
gas-fired heater. It uses air (oxy-
gen) from the room in which it is
installed. Provisions for adequate
combustion and ventilation air
must be provided. Refer to Air for
Combustion and Ventilation sec-
tion on page 4 of this manual.

Advertisement

Table of Contents
loading

Related Manuals for Comfort Glow S26NT

Summary of Contents for Comfort Glow S26NT

  • Page 1 VENT-FREE NATURAL GAS FREESTANDING PEDESTAL STOVE SYSTEM OWNER’S OPERATION AND INSTALLATION MANUAL S26NT 20,000 to 26,000 Btu/Hr ® Thermostatically Controlled Patent Pending WARNING: Improper installa- WARNING: If the information in this manual is not tion, adjustment, alteration, ser- followed exactly, a fire or explosion may result caus- vice, or maintenance can cause ing property damage, personal injury, or loss of life.

  • Page 2: Safety Information

    VENT-FREE NATURAL GAS PEDESTAL STOVE SAFETY 1. This appliance is only for use with the patterns. Altered burner patterns can type of gas indicated on the rating plate. cause sooting. INFORMATION This appliance is not convertible for use 11. Before using furniture polish, wax, car- with other gases.

  • Page 3: Product Identification

    OWNER’S MANUAL PRODUCT PRODUCT IDENTIFICATION FEATURES SAFETY PILOT This heater has a pilot with an Oxygen Deple- tion Sensor Shutoff System (ODS). The ODS/ pilot is a required feature for vent-free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.

  • Page 4: Air For Combustion And Ventilation

    VENT-FREE NATURAL GAS PEDESTAL STOVE AIR FOR PROVIDING ADEQUATE Confined and Unconfined Space VENTILATION COMBUSTION AND The National Fuel Gas Code (ANS Z223.1, 1992 Section 5.3) defines a confined space The following are excerpts from National VENTILATION as a space whose volume is less than 50 Fuel Gas Code.

  • Page 5: Determining Fresh-Air Flow For Heater Location

    OWNER’S MANUAL AIR FOR COMBUSTION AND VENTILATION Continued DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION Determining if You Have a Confined or Unconfined Space Use this worksheet to determine if you have a confined or unconfined space. Space: Includes the room in which you will install heater plus any adjoining rooms with doorless passageways or ventilation grills between the rooms.
  • Page 6 VENT-FREE NATURAL GAS PEDESTAL STOVE AIR FOR COMBUSTION AND 12" VENTILATION Ventilation Continued Ventilation Grills Grills Into Adjoining Room, Into Adjoining VENTILATION AIR Option 2 Room, Remove Option 1 Door into Ventilation Air From Inside Adjoining Building Room, Option This fresh air would come from an adjoining unconfined space.

  • Page 7: Installation

    OWNER’S MANUAL INSTALLATION IMPORTANT: Vent-free heaters add mois- Carefully follow the instructions below. This ture to the air. Although this is beneficial, stove is a freestanding unit designed to set directly on the floor. IMPORTANT: You installing heater in rooms without enough NOTICE: This heater is intended ventilation air may cause mildew to form must maintain minimum wall and ceiling...

  • Page 8: Connecting To Gas Supply

    VENT-FREE NATURAL GAS PEDESTAL STOVE INSTALLATION Apply pipe joint sealant lightly to male WARNING: Never connect threads. This will prevent excess sealant Continued heater to private (non-utility) gas from going into pipe. Excess sealant in pipe wells. This gas is commonly could result in clogged heater valves.

  • Page 9: Checking Gas Connections

    OWNER’S MANUAL INSTALLATION Test Pressures Equal To or Less Than Pressure Testing Heater Gas 1/2 PSIG Connections Continued 1. Close manual shutoff valve (see Fig- Open manual shutoff valve (see Fig- ure 7). CHECKING GAS ure 7). 2. Pressurize supply piping system by ei- CONNECTIONS Open main gas valve located on or near ther using compressed air or opening...

  • Page 10: Installing Logs

    VENT-FREE NATURAL GAS PEDESTAL STOVE INSTALLATION INSTALLING BLOWER Install one plastic bushing provided in blower kit into the 1 " hole in the left ACCESSORY - GA3750 Continued rear of firebox floor. Access hole Tools required: Phillips screwdriver through the rectangular opening in the INSTALLING LOGS rear panel (see Figure 13).

  • Page 11: Operating Heater

    OWNER’S MANUAL INSTALLATION LIGHTING INSTRUCTIONS Continued 13. Install plastic control knob onto output NOTICE: During initial operation shaft of speed control housing (see Fig- of new heater, burning logs will ure 15). Place speed control housing give off a paper-burning smell. just inside control compartment door Orange flame will also be present.

  • Page 12: Inspecting Burners

    VENT-FREE NATURAL GAS PEDESTAL STOVE OPERATING INSPECTING THERMOSTAT CONTROL OPERATION HEATER BURNERS Continued The thermostat control knob can be set to Check pilot flame pattern and burner flame any comfort level between Hi and Lo. The patterns often. 7. Keep control knob pressed in for 30 thermostat will gradually modulate the heat PILOT FLAME PATTERN seconds after lighting pilot.

  • Page 13: Cleaning And Maintenance

    OWNER’S MANUAL CLEANING AND MAIN BURNER 5. Blow air into the primary air holes on the injector holder. MAINTENANCE Periodically inspect all burner flame holes 6. In case any large clumps of dust have with the heater running. All slotted burner now been pushed into the burner repeat flame holes should be open with yellow steps 3 and 4.

  • Page 14: Troubleshooting

    VENT-FREE NATURAL GAS PEDESTAL STOVE TROUBLESHOOTING CAUTION: Never use a wire, WARNING: Turn off heater needle, or similar object to clean and let cool before servicing. Only Note: For additional help, visit DESA ODS/pilot. This can damage ODS/ a qualified service person should International’s Technical Service web pilot unit.
  • Page 15 OWNER’S MANUAL TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Burner does not light after ODS/pilot is lit 1. Burner orifice clogged 1. Clean burner (see Cleaning and Mainte- nance, page 13) or replace burner orifice 2. Inlet gas pressure is too low 2.
  • Page 16 VENT-FREE NATURAL GAS PEDESTAL STOVE TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. •...

  • Page 17: Specifications

    OWNER’S MANUAL SPECIFICATIONS Tarantin Tank Co. PARTS CENTRALS P.O. Box 6129 These Parts Centrals are privately owned Btu (Variable) 20,000/26,000 Freehold, NJ 07728-6129 businesses. They have agreed to support our 908-780-9340 Type Gas Natural Only customer’s needs by providing original re- 1-800-922-0724 Ignition Piezo...

  • Page 18: Illustrated Parts Breakdown

    VENT-FREE NATURAL GAS PEDESTAL STOVE ILLUSTRATED PARTS BREAKDOWN S26NT 105683...

  • Page 19: Parts List

    OWNER’S MANUAL PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 13 of this manual. S26NT PART NUMBER DESCRIPTION QTY. 105441-01 Log Set L98071-03 ODS Pilot (NG)
  • Page 20 VENT-FREE NATURAL GAS PEDESTAL STOVE ILLUSTRATED PARTS BREAKDOWN S26NT 105683...
  • Page 21 OWNER’S MANUAL PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 13 of this manual. S26NT PART NO. DESCRIPTION QTY. 105666-01 Top Panel, Stove 105656-01 Pedestal Stove...

  • Page 22: Warranty Information

    WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standard written warranty.

Table of Contents