Table of Contents
Advertisement
INSTALLATION
Continued
15. Using two screws provided in blower kit,
mount blower speed control housing to mount-
ing tab in left side of lower control compart-
ment (see Figure 18).
16. Check to make sure that the power cord is
completely clear of blower wheel and there
are no foreign objects in blower wheel.
17. Carefully replace stove top panel. Align holes
and replace six screws removed in step 2, page
12. Slide top trim onto top panel. Attach with
2 screws removed in step 1, page 12.
18. Peel off the backing paper and stick the sup-
plied wiring diagram decal on the stove floor
as shown in Figure 17, page 13.
19. Plug power cord into a convenient 3-prong
grounded wall receptacle near the stove.
20. Using speed control knob, turn blower on and
check for operation.
21. All remaining parts from blower kit may be
discarded.
WARNING: ELECTRICAL
GROUNDING INSTRUCTIONS
This appliance is equipped with a
three-prong (grounding) plug for
your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle.
Figure 18 - Installing Blower Control
Housing
14
Blower Speed
Control Housing
www.desatech.com
INSTALLING OPTIONAL BLOWER
ACCESSORY GA3650TA
Tools required: Phillips screwdriver
NOTICE: Shut off gas heater
during the following blower
installation.
1. Remove 2 screws from rear tabs on top trim.
Pull trim forward to remove (see Figure 13,
page 12).
2. Remove three screws from under top lip on
each side of stove to remove top panel (see
Figure 13, page 12).
3. Facing front of stove, carefully slide top panel
forward until it is completely removed from
stove (see Figure 13, page 12).
6. Install one plastic bushing provided in blower
kit into the 1
/
" hole in the left rear of firebox
1
2
floor. Access hole through the rectangular open-
ing in the rear panel (see Figure 14, page 12).
4. Disconnect power cord wires from blower mo-
tor (if connected) (see Figure 15, page 13).
5. Disconnect green ground wire from blower
housing (if connected) by removing screw hold-
ing wire terminal (see Figure 15, page 13).
7. Remove the two blower mounting brackets
from the rear panel by removing two screws
each (see Figure 16, page 13).
8. Attach the two mounting brackets to blower
housing using four screws provided in blower
kit (2 for each bracket) (see Figure 16, page
13). Tighten screws securely. Place blower
assembly temporarily on top of firebox.
9. If screen is installed, carefully lift slightly and
pull forward to remove.
10. If logs are installed, carefully remove and set
aside.
11. Remove three screws and cover plate from
center of firebox back panel. Keep screws but
discard cover plate (see Figure 19).
Cover
Plate
Screws
Firebox Back Panel
Figure 19 - Removing Cover Plate
111417-01B
Advertisement
Table of Contents
