Table of Contents
Advertisement
INSTALLATION
Continued
4. Install one plastic bushing provided in blower
kit into the 1
/
" hole in the left rear of firebox
1
2
floor. Access hole through the rectangular
opening in the rear panel (see Figure 15).
5. Disconnect power cord wires from blower
motor (if connected) (see Figure 15).
6. Disconnect green ground wire from blower
housing (if connected) by removing screw
holding wire terminal (see Figure 15).
7. Remove the two blower mounting brackets
from the rear panel by removing two screws
each (see Figure 16).
8. Attach the two mounting brackets to blower
housing using four screws provided in
blower kit (2 for each bracket) (see Figure
16). Tighten screws securely. Place blower
assembly temporarily on top of firebox.
Blower
Firebox
Top
Figure 16 - Removing Blower Brackets
from Stove and Attaching to Blower
111417-01B
Screws
Blower
Bracket
Screws
www.desatech.com
9. Working from the rear of the stove, place entire
power cord, including speed control housing,
in lower control compartment.
10. Route ends of 3-wire power cord up from the
lower control compartment through the plastic
bushing, then up to the upper cavity of stove
(see Figure 17).
11. Attach the terminal ends of the white and
black power cord wires to the terminals on
the blower motor (see Figure 14, page 12).
Push firmly.
12. Attach the terminal end of the green power cord
wire to the front tab of the blower housing using
screw provided (see Figure 14, page 12).
13. Using the four screws previously removed,
mount blower assembly to stove by reattach-
ing blower brackets to rear panel (see Figure
16). Tighten screws securely.
14. Install plastic control knob onto output shaft of
speed control housing (see Figure 17). Place
speed control housing just inside control com-
partment door in front of stove (see Figure 18,
page 14).
13
Advertisement
Table of Contents
