Using Batteries; Using The Main Battery; Charging The Main Battery; Changing The Main Battery - Avery Dennison Monarch Operator's Handbook Manual

U S I N G B A T T E R I E S
The printer uses two batteries: a main battery and a backup battery.
Battery Use
Main
Running the printer. It is also rechargeable using the Monarch 9462 single-station
or the Monarch 9465 four-station charger.
Backup Maintaining the printer's system settings.
U s i n g t h e M a i n B a t t e r y
The printer's main power source is a 7.4V lithium-ion battery.
Note: The printer only takes this battery. Do not substitute batteries.
You must charge the battery when you receive the printer, even if you do not use it right away.

Charging the Main Battery

To charge the main battery, use either the 9462 single-station or 9465 four-station
battery chargers. Refer to the documentation provided with the chargers for more
information. Charging time is approximately 1.5 – 3 hours.
Warning: The battery might explode if placed on a different charger.

Changing the Main Battery

To change the main battery:
1. Turn the printer over and press the button on the battery compartment door (at the bottom of
the printer's handle) and slide it open.
Turn the printer upright, holding your palm beneath the open battery compartment. Hit the
7.
printer on your hand and catch the battery as it slides out.
8. Insert a new battery into the compartment (connector end first).
Slide the compartment door shut until clicks into place.
9.
Batter y Compartment Door
Button
Main Battery
2

Using Batteries 2-1