Software Setup; Install Display Driver - Matrox PJ-4OLP User Manual

Software setup

This section describes how to install Matrox software for Windows 2000/XP.
You may need administrator rights to install certain software. For more information, see Windows
documentation or contact your system administrator.
Download your Matrox software package
1
Download the latest software package for your product from the Matrox Web site
(www.matrox.com/graphics/support/drivers/latest/home.cfm).

Install display driver

2
Note:
unsupported by your product when your Matrox product is detected as new hardware. If
you aren't prompted to install a display driver, DON'T RESTART your system. Install the
software package you downloaded.
If you do restart your computer,
display driver.
Windows detects new hardware when you restart. If Matrox display drivers haven't been
previously installed, Windows prompts you to install a display driver. Click
install the software package you downloaded. Follow the on-screen instructions.
3 Configure your monitor settings
To take full advantage of your graphics card, make sure the monitor settings for the main
monitor are supported by all 4 monitors connected to your graphics card:
Right-click your Windows desktop background, then click
a
Advanced
If "
b
Under
Click
c
For more information on Windows monitor settings, see Windows documentation.
WARNING:
permanently damaged. For more information, see your monitor manual.
8 Matrox PJ-4OLP – User Guide
Windows XP SP2 (Service Pack 2) – Windows may install a Matrox display driver
! .
Monitor
Hide modes that this monitor cannot display
, select the highest refresh rate listed.
Screen refresh rate
.
!
OK OK
If incorrect software monitor settings are applied, some monitors can be
see page 11 for more information on reinstalling your
" is available, make sure it's enabled.
, then
Cancel
! !
Properties Settings