Mounting Hole Locations - Intel Core 2 Duo User Manual

Setting Up and Configuring the Development Kit—Intel Core 2 Duo Processor and Intel Q35
Express Chipset
environment. Since the board is not in a protective chassis, the user is required to
observe extra precautions when handling and operating the system.
The board is a standard uBTX form factor and provides non-plated mounting holes with
top and bottom ground rings. If the board is not going to be used in a chassis,
standoffs are included for bench top use in the lab environment.
The development kit includes eight hex standoffs and for screws to attach to the board
for bench top use. Four of the standoffs are used to mount the heatsink (refer to
Section 3.3
following mounting hole locations.
1. Insert screw through top mounting hole for the BTX Heatsink. Refer to
the mounting hole location.
2. Place standoff on backside of board and hand tighten to screw. Refer to
for guide.
3. Repeat for additional standoffs on the board until all standoffs are installed. Refer
to Figure 17
Figure 17.

Mounting Hole Locations

October 2007
Order Number: 318476001US
for heatsink installation). Attach standoffs to the screws to the board at the
for recommended mounting hole locations.
® TM
Intel Core
®
2 Duo Processor and Intel Q35 Express Chipset Development Kit
Figure 17 for
Figure 18
J24LB
Recommended
Mounting Hole
Locations
Mounting Hole for
BTX heatsink
Locations
User's Manual
27