To Set System Timers - Mitel 1000 Owner's Manual

Timers
Recall on hold
Recall on transfer
Forward on no answer
Call park
Ringback time duration
Answer machine delay
Programmable message length
Notification delay
Notification interval
Button Hopping
When Button hopping is enabled if you press a second line key
while on a call on another line the first call is disconnected. With
button hopping off the first call is placed on hold when the second
line key is pressed.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'System'.
Press the Scroll Down Key ( ) until 'Button Hopping' is displayed.
Select Button hopping On or Off as required.

To set system timers

You can set various timers from the Programming Extension to suit
your requirements.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'System'.
Press the Scroll Down Key ( ) until 'Timers' is displayed.
Select 'Timers'
Select the required timer to be changed and enter the duration.
(See table below).
Confirm the new time.
Press the Speakerphone Key to finish programming.
001 – 1800
001 – 180
01 – 30
001 – 600
01 – 30
01 – 30
30 - 180
60-1800
60-900
Recall on Hold
This is the time that elapses before a call, which has been placed
on hold, rings back the extension that put the call on hold.
Recall on transfer
This is the time that elapses before a call, which has been
transferred and not answered, rings back the extension that
attempted the transfer.
84
Range Default setting
90 seconds
90 seconds
11 seconds
180 seconds
30 seconds
10 seconds
120 seconds
900 seconds
300 seconds