Mitel 1000 Owner's Manual page 72

Type of restriction
No restriction
Restrict codes in Table 2
Restrict codes in Table 2 and 3
Internal and emergency calls only
Allowed codes that can be combined with Class 2 or 3
Restricted codes that can be combined with Class 1, 2 or 3
When the name is entered, select 'Confirm'. You will be presented
with the Extension Menu and can continue programming other
names.
Press the Speakerphone Key to finish programming.
Class of Service
Each extension may be programmed for a Class of Service. This
determines the type of call the extension is allowed to dial. Four
tables, which can be programmed with up to fifty codes, are used to
implement six Classes of Service:
By default, all extensions are in Class 1, that is, they have no
restriction placed on them.
An extension placed in Class 2 is restricted from dialing the codes
programmed in Table 2. (Table 2 would typically be programmed
with the international access code 00).
An extension placed in Class 3 is restricted from dialing the codes
programmed in Tables 2 and 3. (Table 3 would typically be
programmed with non-local national access codes).
An extension placed in Class 4 is restricted to internal and
emergency, (911), calls only.
An extension can be placed in Class 5 in addition to being in Class
2 or 3. In this case the codes programmed in Table 5 are allowed.
An extension can be placed in Class 6 in addition to being in Class
1, 2 or 3. In this case the codes programmed in Table 6 are
restricted.
The following table shows the types of restriction for the different
Classes of Service available:
The emergency code is 911. It cannot be barred.
Both Classes 5 and 6 can be associated with the same extension.
Class 5 cannot be associated with Class 4 extensions.
To set up Class of Service access tables
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'System'.
Press the Scroll Down Key ( ) until 'Class codes' is displayed.
Select 'Class codes'.
Select the 'Table' to which you want to assign codes. (Table 2, 3,
Allowed Table, or Restricted Table).
Select an 'Index number' and enter the code.
72
Table Class
- 1
Table 2 2
Table 3 3
- 4
Table 5 5
Table 6 6