Operation Setting Menu - Integra DSR-4.8 Instruction Manual

DVD Onscreen Setup Menus—Continued

Operation Setting Menu

Setting the Parental Lock
With the Parental Lock function you can block access to
certain scenes that the authors have flagged as being
unsuitable for children.
1
Select "Operation Setting" menu
in the setup.
2 Use the Up/Down [
tons to select "Parental Lock",
Remote controller
and then press the [Enter] but-
ton.
The password (security code) input
screen appears.
3
Enter the security code using the
remote controller's number but-
tons, and then press the [Enter]
button.
The default security code is "8888".
You can change the security code in the
next section.
4
Use the Up/Down [
tons to change the level of paren-
tal lock, and then press the
[Enter] button.
At level 8 parental lock is off, with level
1 being the strictest level.
Notes:
• When entering a security code, you can use the [CLR]
button to delete the numbers entered so far, if neces-
sary.
• Not all discs use parental lock. See the disc's sleeve
notes for details.
64
• Discs with parental lock may cut certain scenes,
replace certain scenes with children-friendly scenes,
or prevent playback of the entire disc.
Change the Security Code
To change the Security Code, confirm your existing code
then enter a new one.
1
]/[ ] but-
2
Remote controller
3
]/[ ] but-
4
Note:
If you forget your security code, enter "8888" instead.
"8888" is a security code that can always be used.
Select "Operation Setting" menu
in the setup.
Use the Up/Down [ ]/[
tons to select "Security Code",
and then press the [Enter] but-
ton.
The password (security code) input
screen appears.
Enter the existing security code
using the remote controller's
number buttons, and then press
the [Enter] button.
The default security code is "8888".
Even if a new security code has been
entered, the code "8888" can still be
used.
Once the security code has been
entered, the new security code input
screen appears.
Enter the new security code
using the remote controller's
number buttons, and then press
the [Enter] button.
The new security code has been set.
] but-