Listening To The Radio; Using The Tuner - Integra DSR-4.8 Instruction Manual

Listening to the Radio

Number
buttons
Tuning

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
Listening to the Radio
Use the Input [
select either AM or FM.
In this example, FM has been selected.
Band
(Actual display depends on country)
Input
Search
Memory
CLR
Preset
Mode
]/[ ] button to
Frequency
Tuning into Radio Stations
■ Auto Tuning Mode
1 Press the [Mode] button so that
the AUTO indicator appears on
the display.
2 Press the Tuning [
Searching stops when a station is
found.
To stop searching, press Stop [ ] but-
ton.
When tuned into a station, the
When tuned into a stereo FM station, the FM ST indica-
tor appears on the display, as shown.
AUTO FM ST
AUTO FM ST
Note:
This procedure can also be performed on the DVD
receiver by using its Tuning/Preset [ ]/[ ] button. Press
the Tuning/Preset [ ]/[ ] button to start searching for a
few seconds. Pressing the Tuning/Preset [ ]/[ ] button
again stops the searching.
After this, press the button repeatedly to change the fre-
quency one step at a time.
■ Manual Tuning Mode
1 Press the [Mode] button so that
the AUTO indicator disappears
from the display.
2 Press and hold the Tuning [
[ ] button.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
HOLD
Radio Frequency can be changed in 0.2 MHz steps for
FM and 10 kHz steps for AM.
In Manual Tuning mode, FM stations will be in mono.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
]/[ ] button.
indicator appears.
]/
39