Display The Configuration Utility By Using Cisco Configuration Assistant 2.1 Or Higher - Cisco Small Business AP541N Administration Manual

Getting Started
Connecting the Access Point to a PC
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Display the Configuration Utility by Using
Cisco Configuration Assistant 2.1 or higher
Use Cisco Configuration Assistant 2. 1 or higher (CCA) to configure the access
point when it is deployed in a Cisco Smart Business Communications System
(SBCS) network with a UC520 or SR520.
DHCP client
This procedure assumes you are familiar with CCA. You can find additional
information about CCA at
tsd_products_support_series_home.html
To configure the access point by using CCA:
Connect the Ethernet port on the access point to a switch port on a SBCS device.
Power on the Cisco AP541N.
Connect a PC with CCA installed to any access switch port on the UC520 or
SR520.
Create a new CCA site by entering a name and the IP address of the UC520 or
SR520.
Connect to the CCA site by using the appropriate login credentials.
Click Window > Topology View.
Internet
http://www.cisco.com/en/US/products/ps7287/
1
9