Cisco Small Business AP541N Administration Manual page 54

Wireless
Modifying Wireless Radio Settings
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Table 10 Radio Settings Field Descriptions
Field Description
The Physical Layer (PHY) standard the wireless radio uses.
Mode
NOTE:
cannot be changed.
NOTE:
the country code setting.
Select one of the following modes for the wireless radio
interface:
If the Wireless Radio Interface is set to Off, the Mode
The modes available on your access point depend on
• 802. 1 1a. Only 802. 1 1a clients can connect to the access
point.
• 802. 1 1b/g. 802. 1 1b and 802. 1 1g clients can connect to
the access point.
• 802. 1 1a/n. 802. 1 1a clients and 802. 1 1n clients operating
in the 5-GHz frequency can connect to the access point.
• 802. 1 1b/g/n (default). 802. 1 1b, 802. 1 1g, and 802. 1 1n
clients operating in the 2.4-GHz frequency can connect
to the access point.
• 2.4 GHz 802. 1 1n. Only 802. 1 1n clients operating in the
2.4-GHz frequency can connect to the access point.
• 5 GHz 802. 1 1n.Only 802. 1 1n clients operating in the 5-
GHz frequency can connect to the access point.
4
49