Cisco Small Business AP541N Administration Manual page 137

7
132
Table 35 Access Points in the Cluster
Field
MAC Address
IP Address
Table 36 describes the cluster information to configure for a member.
Table 36 Clustering Options
Field
Location
Cluster Name
Description
Media Access Control (MAC) address of the access
point.
The address shown here is the MAC address for the
bridge (br0). This is the address by which the access
point is known externally to other networks.
The IP address for the access point.
Each IP address is a link to the Administration Web
pages for that access point. You can use the links to
navigate to the Administration Web pages for a
specific access point. This is useful for viewing data
on a specific access point to make sure a cluster
member is picking up cluster configuration changes,
to configure advanced settings on a particular
access point, or to switch a standalone access point
to cluster mode.
Description
Enter a description of where the access point is
physically located. The location can be a maximum of 64
characters in length. All alphanumeric characters except
double quote (") are valid. Null or empty space is not
allowed.
Enter the name of the cluster for the access point to join.
The name can be a maximum of 64 characters in length.
All alphanumeric characters except double quote (") are
valid. Null or empty space is not allowed.
The cluster name is not sent to other access points in the
cluster. You must configure the same cluster name on
each access point that is a member of the cluster. The
cluster name must be unique for each cluster you
configure on the network.
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Clustering Multiple Access Points
Managing Access Points in the Cluster