Display The Configuration Gui And Enable The Radio - Cisco AP541N Quick Start Manual

REVIEW DRAFT — CISCO CONFIDENTIAL
Parameter
voice SSID
wireless security
Display the Configuration GUI and Enable the
Radio
For security reasons, the radio is off by default. This procedure describes
how to access the GUI and enable the radio.
Before you begin:
• Verify that you have a power source for theCisco AP541N. If you will be
deploying the Cisco AP541N by using PoE, it might be necessary to
temporarily power the device by using the provided power supply or
by connecting it to a hub or switch that provides PoE.
• The Cisco AP541N IP address is required. If the IP address is unknown,
you can reset the device to use the static default Cisco AP541N IP
address by using the
Default Settings"
To configure the access point by using a PC directly connected to the
Cisco AP541N or connected through a hub or switch:
Power on the PC and configure the PC IP address to an IP address
S 1
TEP
in the same subnetwork. The default Cisco AP541N IP address is
192.168.10.10. For example, you can set the:
PC IP address to 192. 1 68. 1 0.250
PC IP subnet mask to 255.255.255.0
PC Default Gateway to 192.168.10.10.
Connect an Ethernet cable to an Ethernet port on the PC.
S 2
TEP
Connect the other end of the PC Ethernet cable to an Ethernet port
S 3
TEP
on a switch, hub, or the Cisco AP541N Ethernet port. If you
connected the PC through a switch or a hub, connect the Cisco
AP541N to that device by using another Ethernet cable.
Power on the access point.
S 4
TEP
Open a Web browser window. If you are prompted to install an
S 5
TEP
Active-X plug-in when connecting to the device, follow the
prompts to accept the plug-in.
10 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Default Value
cisco-voice (VLAN 100)
None
"Returning the Cisco AP541N to the Factory
procedure.