Cisco Small Business AP541N Administration Manual page 67

4
NOTE
62
IEEE 802. 1 X Authentication
IEEE 802. 1 X is the standard defining port-based authentication and infrastructure
for doing key management. Extensible Authentication Protocol (EAP) messages
sent over an IEEE 802. 1 1 wireless network using a protocol called EAP
Encapsulation Over LANs (EAPOL). IEEE 802. 1 X provides dynamically-generated
keys that are periodically refreshed. An RC4 stream cipher is used to encrypt the
frame body and cyclic redundancy checking (CRC) of each 802. 1 1 frame.
This mode requires the use of an external RADIUS server to authenticate users.
The access point requires a RADIUS server capable of EAP, such as the Microsoft
Internet Authentication Server. To work with Windows clients, the authentication
server must support Protected EAP (PEAP) and MSCHAP V2.
You can use any of a variety of authentication methods that the IEEE 802. 1 X mode
supports, including certificates, Kerberos, and public key authentication. You must
configure the client stations to use the same authentication method the access
point uses.
After you configure the security settings, you must click Apply to apply the changes
and to save the settings.
Table 13 IEEE 802.1X
Field
Use Global RADIUS
Server Settings
RADIUS IP Address
Description
By default each VAP uses the global RADIUS settings
that you define for the access point at the top of the
VAP page. However, you can configure each VAP to
use a different set of RADIUS servers.
To use the global RADIUS server settings, make sure
the check box is selected.
To use a separate RADIUS server for the VAP, clear the
check box and enter the RADIUS server IP address
and key in the following fields.
Enter the address for the primary RADIUS server for
this VAP.
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Modifying Virtual Access Point Settings
Wireless