Cisco Small Business AP541N Administration Manual page 136

Clustering Multiple Access Points
Managing Access Points in the Cluster
Figure 33 Cluster Information and Member Configuration
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
If clustering is currently disabled on the access point, the Enable Clustering
button is visible. If clustering is enabled, the Disable Clustering button is visible.
You can enter clustering option information whether clustering is enabled or
disabled.
Table 35 describes the configuration and status information available on the
cluster Access Points page when clustering is enabled.
Table 35 Access Points in the Cluster
Field
Status
Location
Description
If the status field is visible, the access point is
enabled for clustering. If clustering is not enabled,
then the access point is operating in stand-alone
mode and none of the information in this table is
visible.
To disable clustering on the access point, click
Disable Clustering.
Description of where the access point is physically
located.
7
131