4. Battery Pack
By default, the scanner is in Power Saving mode. To power on the unit, press the trigger key
for a few seconds. If the scanner is not in use for a while, it will go into sleep mode and the
trigger key must be pressed for a few seconds before scanning to reactivate the unit.
To fully charge the main battery, connect the dedicated AC adapter or plug the scanner into
the charging cradle.
4.1. Using the Charging Cradle
Figure 6 shows the procedure for inserting the OPI 4002 handheld scanner into the CHG
4001 charging cradle.
4.2. Scanner LED Indicator State
Table 4 lists the state of the scanner based on the scanner LED.
Color
Green
Good Read
Red
Blinking->Transmission
error
Red
Charging
Green
Green -> Red
Red
Blinking
Figure 6: Inserting the scanner into the charging cradle
Indication
A barcode was successfully decoded.
There was a data transmission error to USB dongle.
During charging on the cradle.
Changing color from green to red when the battery is full charged.
Battery voltage drop when pressing the trigger key and charging is
needed. Cannot read any barcodes.
Table 4: Scanner status—LED indicator state
Description
13
Opticon
OPI 4002
Instruction Manual