Horn Inspection; Drive Chain Inspection - KYMCO Quannon 150 Owner's Manual

OPERATION
1 1 1 1 1

Horn inspection

1. Press the horn button 1 on the left handlebar control to
confirm that the horn sounds and it has adequate volume.
Proper light and horn function is essential for your riding
safety. So you can properly see the road, and others
can see you, replace any failed bulbs immediately. Clean
or replace any damaged or dirty lenses immediately. If
your horn fails to operate, or the sound is weak, have it
adjusted or replaced. Contact your KYMCO dealer im-
mediately if you have any lights or horn-related service
needs.
28

Drive chain inspection

Before each ride, check the drive chain on your motorcycle.
2 2 2 2 2
2 2 2 2 2
1. Check the drive chain slack 2 and confirm that is not too
loose or is too tight.
Drive chain slack:
2. To adjust the chain slack, loosen the rear axle nut 3.
3. Turn the adjuster nuts 4 in equal increments at the back
of the swingarm until the proper amount of drive chain slack
is achieved. Use the punch marks stamped into the
swingarm for reference while adjusting the slack. Once the
proper slack is set, tighten the axle nut.
Improper drive chain slack adjustment will cause pre-
mature chain wear. Clean the drive chain with kero-
sine. To prevent premature wear and rust, use a chain
lubricant approved for use on O-ring type drive chains.
3 3 3 3 3
4 4 4 4 4
0.4 - 0.8 in (10 - 20mm)