Installing The Machine; Off-Line Tests; Starting And Stopping The Print Test - Olivetti PR2 E Service Manual

3.2.2 INSTALLING THE MACHINE
Position the machine for operation, making sure that it complies with the information provided in section
3.1.
Make sure that the voltage rating indicated on the electrical data plate corresponds to the local mains.
Plug the power cord into the electrical wall outlet and then power on the printer.
Make sure that the printer powers on by checking the mechanical reset and the lighting of the ON LED
on the console.
If other LEDs other than the ON LED remain lit, refer to section 2.2.3 "Error Messages".
3.3 OFF-LINE TESTS
A print test can be run to make sure that the printer works correctly before actually connecting it to the
system.
3.3.1 STARTING AND STOPPING THE PRINT TEST
Proceed as follows to activate the print test:
-
Power off the printer
-
Power on the printer while pressing the STATION 2lEJECT button on the console.
-
After printer initialization, insert an A4 sheet of paper into the front feed slot until triggering the paper
alignment photosensor.
The machine will automatically feed the sheet of paper and start printing the test. The sheet of paper
is automatically expelled at the end of the test. To repeat the test simply insert a new sheet of paper.
To stop the print test, power off the machine.