Olivetti PR2 E Service Manual page 214

1. OVERVIEW
1 . l INTRODUCTION
The PR 2 is a specialized mid-range printer specifically designed for the banking environment. It can
handle documents (single or multicopy) or savings books used during cash deposit or withdrawl
transactions.
Very versatile, this printer can also be used in the Public Administration front office environments and
in Post Offices.
It is equipped with two options, one for automatic form feeding and the other for the reading of code
lines on checks.
1 .l .l
PR2 FACTORY DEFAULT CONFIGURATION
The basic version of the PR2 is configured at the factory in two versions that differ according to the
type of main board used:
- PR 2 equipped with a main board with an RS232 C serial interface: PR 2-S1 0
- PR 2 equipped with a main board with a double interface, an IEEE 1284 bidirectional parallel
interface and an RS232 C serial interface: PR 2-D10. By means of the Setup facility, the
autoswitching of the interface can be selected.
When equipped with a horizontal magnetic band read/write unit, the PR2 printer is named PR 2-S12
depending on the type of interface it is equipped with. When the printer is equipped with a MlCR check
reader in addition to the horizontal magnetic band readhvrite unit, it is named PR 2-S12MMICR.
When equipped with a vertical magnetic band read/write unit, the printer is named PR 2 4 1 3 .
In case the printer comes with the vertical magnetic band option, it will be necessary to specify the
savings book alignment to either the left (DOC 007) or right (DOC 009) of the input slot.
6833 1
O H Service
Manual
1 - 1