Listening To The Radio; Listening To An External Audio Device (Aux Mode) - Innovative Technology ITVS-750 User Manual

Wooden music centre with recordable cd player

Hide thumbs Also See for ITVS-750:

Manual (21 pages)

User manual (20 pages)

Table of Contents

6. "P-02" is displayed. Repeat steps 4 thru 5 to program the additional tracks.

7. When the selection of track numbers has been finished, press the PLAY button (

program playback.

8. To cancel the program mode, press the STOP ( ).

To check the programmed order

In the stop mode, press (

been programmed.

To add a track to the end of the programmed order:

In the stop mode, press the PROGRAM button.

Select a track number by pressing (

The current track will be added to the end of the program.

To delete the last track from the programmed order:

In the stop mode, press the CLEAR button to delete the last track from the program.

To clear the programmed order:

Press STOP when the CD is already stopped, or press OPEN/CLOSE, POWER, FM/AM,

PHONO, or AUX

1. Press the "FM/AM" button (1).

Press again to switch between AM and FM

2. Tune to the desired station

using the Radio Tuner Knob (2).

Note: In FM Mode,The "TUNED/ST" indicator

lights up green when tuning the Radio Tuner Knob;

The "TUNED/ST" indicator lights up orange when

a station is correctly tuned in.

Adjusting for Best Reception

AM broadcast: Rotate the unit to find the best position.

FM broadcast: Extend and reposition the FM antenna.

Listening to an External Audio Device (AUX Mode)

In AUX (auxiliary) mode, this unit can play audio from an external audio source (iPod, MP3 Player,

Portable CD Player, etc.)

There are two AUX INs(front and rear). When connecting a device that has a headphone jack, use

the cable with 3.5mm plugs on either end with the front AUX IN jack.

The rear set of AUX IN jacks (red and white) can be used with devices that use RCA connections

(DVD players, etc.).

1. Plug one end of the AUX IN cable (included) into the AUX IN (on the front or back of the unit).

2. Plug the other end of the cable into the headphone jack (or RCA jacks) of the external audio

source.

) repeatedly to show the track numbers that have

), then press the PROGRAM button.