Table of Contents
Advertisement
CONNECTING THE EXTERNAL SPEAKERS
The speaker input sockets are located at the back of the main unit.
1. Unwrap the speaker wire from the left speaker and plug it into the left (L)
speaker socket on the main unit.
2. Unwrap the speaker wire from the right speaker and plug it into the right (R)
speaker socket on the main unit.
3. Make sure the speaker cables are not run in areas where they could cause
danger.
PRELIMINARY
Before using your audio system, the protective packing should be removed from the
CD compartment. To remove the protective packing:
1. Press the EJECT/ENTER button to the right of the CD door to open the CD door.
2. Remove the protective packing from the CD compartment.
3. Close the CD door by pressing the EJECT/ENTER button again.
FM Antenna
Unwrap the FM antenna and extend it fully. You may need to adjust the position of
the antenna to get optimum reception.
Connecting to a Power Source
1. Check that the mains voltage on the rating plate on the back of the main unit is
the same as the voltage in your area.
2. Plug the electric plug into the wall socket. The CD Stereo System is now ready
for use.
Standby Control
Press the POWER button to turn the unit ON. Press again to turn the unit OFF.
NOTE: When leaving the unit unattended for long periods (such as vacations),
please disconnect the power plug from the mains supply.
1. Press the FUNCTION BUTTON to switch to the FM RADIO. The display will
show a radio station: "87.5".
2. Tune to a desired radio station. The frequency is indicated on the display.
• MANUAL TUNING: Press the TUN+ or TUN- button briefly and the frequency
will tune up or down.
• AUTO SEARCHING: Press the TUN+ or TUN- button for more than 2
seconds, the radio frequency will start to change on the display. Once a
station is found, the radio will stop searching and start to broadcast
immediately.
3. Re-position the antenna if necessary.
GETTING STARTED
LISTENING TO THE RADIO
5
Hide quick links:
Advertisement
Table of Contents
