Listening To A Cassette Tape; Recording To A Cd-R / Cd-Rw; Aux Operation - Innovative Technology ITVS-750 User Manual

Important: If both the front and rear AUX INs are connected to AUX IN cables at the same time, only
the front one will be active.

AUX OPERATION

Please use this function to record from other sources such as CDs, karaokes and radio.
We also recommend using this function to make the cassette tape to CD recording much easier.
Please use the included AUX cable and connect one end to the AUX jack on the front. Connect the
other side end to a portable boom box or any other stereo, CD player, MP3 players, Karaoke, etc...
to its headphone jack.
Please leave the function as AUX and follow the recording instructions.
1. Load an audio cassette tape into the unit (located on the
left side of the unit). Playback will automatically begin.
2. Press button halfway to Fast Forward the tape.
Press button lightly and playback will resume.
3. Press button completely down to end playback and eject Tape.
About CD-R and CD-RW discs
- CD-R discs can be recorded once only, and cannot be erased or re-recorded. However, if space is
available on the disc (and the disc has not been finalized), additional material can be recorded.
- CD-RW discs allow you unfinalize the disc, and erase the last track or the entire CD. They may be
reused for new recordings.
Note: CD-RW discs may not play correctly on every CD-player. CD-R, by contrast, are playable on
most CD players.
Important: Never turn the power off or unplug the power cord while "--- Busy" is displayed.
Whenever "--- Busy" is displayed, all buttons will be temporarily deactivated.
Please read through all the steps below before beginning your recording.
BEFORE RECORDING
Audio from the PHONO, TAPE or AUX sources can be recorded on the CD recorder.
Prepare the audio source for recording
1. Select the desired audio recording source by pressing the corresponding selector button.
("PHONO," "TAPE," or "AUX")
2. Prepare the appropriate audio source for normal play (external audio device / vinyl record /
cassette tape).
3. Load a CD-R / CD-RW and close the CD tray.
4. Make sure "NO TOC" and "CD-R"(or "CD-RW') appear on the top left of the display. If they do not
appear, recording functions will not work.
Select Auto Track Increment Selection Mode
Tracks can be set to assign automatically when the input sound level drops below a certain limit
(-20db/-30db/-40db ) for more than 2 seconds.

Listening to a Cassette Tape

Recording to a CD-R / CD-RW

Note: "NO TOC" is an abbreviation of "No table of contents,"
indicating a blank CD.
11