Finalizing A Cd; Entering Recording (Play) Mode - Innovative Technology ITVS-750 User Manual

2. Test play the audio source to be recorded and adjust "REC LEVEL" Knob to set
the recording volume so that its loudest output does not exceed the "OVER"
indicator on the meter on the lower right of the display.
Note: Be sure not to set the recording volume too low – doing so will result in
very low playback volume levels.
3. Once the recording volume level is set, reset the audio source so it is ready for recording.

Entering Recording (Play) Mode

1. Press the PLAY/PAUSE (
( ) will appear on the left of the screen, indicating that recording is in progress.
2. Begin playing the audio source as normal.*
*Manual Track Increment Assignment
Note: "The TRACK INCREMENT" button works regardless of the MANUAL/AUTO REC setting.
During recording, press the TRACK INCREMENT to end the current track and begin a new one.
The current track number will be indicated on the display.
To Pause Recording Temporarily (Recording Paused Mode).
Press the PAUSE button (
To resume recording, press the PLAY/PAUSE button (
Important: Every time recording is paused or stopped, a new track number will always be
assigned. It is not possible to record in two "stages" within one track.
3. Press the STOP button ( ) to stop recording.
Note: When the rotation of the turntable stops, the recording will stop automatically. However, to
avoid unwanted noise from the tone arm, stop the recording manually by using the STOP button.

FINALIZING A CD

1) After pressing stop, press the "CD" function button.
2) After pressing the "CD" button, "BUSY" will show on the display.
3) After the "busy" display is gone and shows the number of tracks and duration of the recorded time
on your CD.
4) Press the "FINALIZE" button and "FiN-d" will show on the display.
5) Then press the "PLAY/PAUSE" button.
6) The CD will turn and you will have "BUSY" again showing on the display.
7) When the CD is completely finalized, the CD tray will come out automatically and the recorded and
finalized CD can be played in other players.
Before a CD-R or CD-RW can be played in a standard CD Player, it must be finalized. During
finalization, a Table of Contents (TOC) is written to the CD.
Once a CD-R disc is finalized, no more tracks can be recorded on it.
By contrast, a finalized CD-RW disc can be "unfinalized" to allow
additional recording.
1. Press the "FINALIZE" button when in stopped mode. If you are not in
stopped mode, press STOP ( ). "FIN—d" will appear on the display.
Note: To cancel the finalizing process at this point, press STOP ( ).
2. Press the "PLAY" ( ) button to start finalizing. "--- BUSY" will appear
on the display. Wait until this message disappears. When finalization of the disc is complete, the
CD tray will open automatically.
Note: The finalization time is dependent on the contents that have been recorded, and may take a
) button to begin recording.
). The recording process will be temporarily paused.
) again.
13