Wall Mounting - Teac MC-DX55 Owner's Manual

C Subwoofer
Connect the "TO SUBWOOFER" and the "FROM MAIN"
sockets using the supplied cable.
< Connect the Connectors in the direction as figured.
D
SPEAKERS
Connect the left speaker's plug to L, and the right speaker's
plug to R.
< Do not connect anything other than speakers to these
terminals.
E
AC Power Cord
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord. Never pull or yank on the power cord.
F POWER switch of the Subwoofer
Use this switch to turn the system on or off.
The equipment draws a nominal amount of power from
the AC outlet even with its POWER switch in the OFF
position.
< If the power switch of the subwoofer turned off, the
settings kept in memory (clock, preset stations, timer
setting) will be erased.
To avoid loosing your settings, it is advisable to keep this
switch ON when not in use.
G
AUX IN
You can connect a portable audio player to this jack.
Connect the LINE OUT or PHONES jack (audio output jack)
of the player using the supplied stereo mini plug cable.
When using the PHONES jack of your mini player, you must
adjust the volume of the mini-player or you may hear no
sound from your MC-DX55.

Wall Mounting

You can mount the left and right speakers on a wall.
Precautions
< Be aware that the length of the cables are approximately 2 m.
Do not attempt to mount the speakers too far from the main
unit.
< Drill holes into solid wall support, such as wooden frame or
concrete wall.
< TEAC supplies these brackets as a convenience to the product
owner. Consult your local building codes and exercise all
necessary caution when mounting these brackets. If you are
unsure how to use the supplied brackets, consult with a local
tradesmen or building supply expert.
To hook on the wall
1
Secure the brackets on the wall using the supplied screws.
< As a convenience, a set of tapered plastic anchors is supplied.
If you chose to use these anchors, drill a pilot hole using a
6mm drill bit then tap the anchor into the pilot hole.
Only use these anchors if they are appropriate for the
materials onto which the unit is to be mounted. Consult your
local hardware store if you are uncertain.
2
Hang the speakers to the mounting tabs.
Speaker
1
2
5