Wall Mounting; Remote Control Unit - Teac CS-X8 Owner's Manual

Wall Mounting

You can mount the center unit and/or the left and right speakers
on a wall.
Option: Attatch the supplied adapter brackets.
Precautions
< Be aware that the length of the speaker cable is
approximately 10 feet (3 m). Do not attempt to mount the
speakers too far from the main unit.
< Drill holes into solid wall support, such as wooden frame or
concrete wall.
< As a convenience, a set of tapered plastic anchors is supplied.
If you chose to use these anchors, drill a pilot hole using
either a 1/4" or 6mm drill bit then tap the anchor into the
pilot hole.
Only use these anchors if they are appropriate for the
materials onto which the unit is to be mounted. Consult your
local hardware store if you are uncertain.
< TEAC supplies these brackets as a convenience to the product
owner. Consult your local building codes and exercise all
necessary caution when mounting these brackets. If you are
unsure how to use the supplied brackets, consult with a local
tradesmen or building supply expert.
To hook on the wall
1 Use the supplied template to determine drilling points.
2 Secure the brackets on the wall.
3 Scew the mounting tabs into the brackets.
Note:
Before going on, make connections between the main unit
and the speakers by referring to the next page.
4 Hang the main unit and/or the speakers to the mounting
tabs.
MAIN UNIT ADAPTER SP UNIT ADAPTER

Remote Control Unit

The provided Remote Control Unit allows the unit to be operated
from a distance.
When operating the remote control unit, point it towards the
remote sensor on the front panel of the unit.
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there
are any obstacles between the unit and the remote control.
< If the remote control unit is operated near other products
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may also
operate incorrectly.
Battery Installation
1
2
3
1 Remove the battery compartment cover.
2 Put in the lithium battery (CR2032, 3V).
3 Close the cover.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the battery is exhausted. In this case, replace
the battery with a new one.
Precautions concerning batteries
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
7