Changing To The Ini-9100U/9100Uw As The Bootable Host Adapter - Initio INI-9100U User Manual

4. Change the directory and rebuild the UNIX kernel:
cd /etc/conf/cf.d
. /link_unix
5. You have completed the link procedure for the Initio device driver.
Exit and reboot the system.
6. For further information regarding removing the Initio driver for SCO
Unix, please refer to Appendix A, Troubleshooting in this User's
Manual
Changing to the INI-9100U/9100UW as the bootable host
adapter:
1. Insert the INITIO INI-9100U/9100UW DRIVER INSTALLATION
DISK 2 diskette into floppy drive.
2. Type: "installpkg" under command prompt and press <ENTER>, A
system screen similar to that of figure 10-5 will be shown
Type: i91u <ENTER>
3. Change the mscsi file:
cd /etc/conf/cf.d < ENTER >
cp mscsi mscsi.bak < ENTER >
vi mscsi < ENTER >
In the example below, The XXXX would be replaced with i91u.
< ENTER >
< ENTER >
10-6
.