Updating Interrupts And Hardware Settings; Installing The Initio Driver In A New Sco Unix System - Initio INI-9100U User Manual

Updating interrupts and hardware settings

The following interrupt configuration settings are suggested as the most
effective means of providing a controller interrupt to the host adapter:
Host Adapter interrupt levels available are 9,11, 15, (IRQ 11 is
recommended)
Avoid using interrupt 10 as the controller interrupt.
Set first SCSI disk ID to 0 (first time install requirement)
Set tape target ID to 2. (If tape is in use)
Set CD-ROM target ID to 5. (If CD-ROM is in use)
Please Refer to your system documentation to set the interrupt levels and your
peripheral documentation for help in setting SCSI IDs.

Installing the Initio driver in a new SCO UNIX system

1. Insert the SCO UNIX N1 boot disk into the floppy drive and turn on
the system. A screen similar to the following will be displayed (see
figure 10-1):
2. Type: link < ENTER >. The system will respond by displaying the
following screen (see figure 10-2):
figure 10-1 SCO UNIX system boot screen
10-3