Ibm Os/2; Overview; Installation - Initio INI-9100U User Manual

IBM OS/2 Driver Installation

Overview

The Initio INI-9100U/9100UW OS/2 driver will support OS/2, 3.0 & 4.0. The
device driver for OS/2 is copied from the INITIO INI-9100U/9100UW
DRIVER DISK 1 to your hard drive where it is initialized during boot-up.
The installation of Initio device drivers to support OS/2 include the following
software files and may be found on the INITIO INI-9100U/9100UW DRIVER
INSTALLATION DISK 1:
\OS2\INI910U. ADD
\OS2\INI910U.DDP
Reference Documentation:
OS/2 installation and user's guide
The systems setup and installation guide
The documentation for system peripherals
Initio documentation for the SCSI host adapter

Installation

The INI-9100U/9100UW driver developed for OS/2 will be installed on the
disk drive used for system initialization. The driver is loaded during the system
boot routine and will remain resident on the drive. Installation of the drivers
can be accomplished by following one of the procedures listed:
New OS/2 Installation
Adding INI-9100U/9100UW host adapter to existing OS/2
The steps used to install the Initio drivers have different system requirements
that may affect basic operation if not installed properly. It is strongly suggested
INI-9100U/9100UW SCSI Host Adapter OS/2
driver.
Script file for installing INI910U.ADD
9-2