Installing A New Windows Nt System And Initio Driver Without Floppy Disks - Initio INI-9100U User Manual

Installing a new Windows NT system and Initio driver without
floppy disks
For computer systems installing or upgrading to Windows NT from a floppyless
setup such as a share on your network, these instructions will guide you
through the INI-9100U/9100UW host adapter driver installation. The
Windows-NT driver will be found on the INITIO INI-9100U/9100UW
DRIVER DISK 1. It is important that the hardware has been installed
successfully before proceeding further.
1. Execute a floppyless setup as described by the Windows NT System
Administrator's Guide.
2. When SETUP begins to load, the screen will turn from black to blue with
the text "SETUP IS INSPECTING YOUR COMPUTER'S HARDWARE
CONFIGURATION..." at the top.
Press the F6 key to interrupt this process. You will have two seconds
in which to press this key.
Follow the instructions on the screen until you are asked to specify a
SCSI driver.
3. Insert the INITIO INI-9100U/9100UW DRIVER DISK 1 into your local
floppy disk drive, and press <ENTER>.
Select: Initio INI-9100U/9100UW SCSI Host Adapter
4. The Initio host adapter driver is now installed
7-9