Overview; Installation - Initio INI-9100U User Manual

Microsoft Windows-NT Driver Installation

Overview

The Initio INI-9100U/9100UW host adapter will support Windows-NT
v3.5x/4.0 with the addition of a software driver. A software driver allows the
host computer the ability to transfer data over the SCSI bus. The device driver
for Windows-NT is copied from the Initio driver installation diskette to your
hard drive where it is loaded onto the computing system during installation.
The following files are used for installation and may be found on the INITIO
INI-9100U/9100UW DRIVER DISK 1:
INI910U.SYS
TXTSETUP.OEM
OEMSETUP.INF
Reference Documentation:
Windows-NT installation and user's guide
The systems setup and installation guide
The documentation for system peripherals
Initio documentation for the SCSI host adapter

Installation

The INI-9100U/9100UW driver developed for Windows-NT will be installed on
the hard drive used for system initialization. The driver is loaded during the
system boot routine and will remain resident on the drive. This is accomplished
by following one of the four installation procedures listed:
New Windows-NT installation
Adding or updating the INI-9100U/9100UW Host Adapter Driver to an
existing Windows-NT System
INI-9100U/9100UW SCSI Host Adapter Windows-NT
miniport driver.
Script file for installing INI910U.SYS during the text
setup phase.
Script file for installing INI910U.SYS during the
windows phase.
7-2