Operating At More Than One Base Station - Gigaset 2011 Operating Instructions Manual

giga2011.bk : kap17.fm5 Seite 79 Freitag, Juli 9, 1999 2:26 PM
9.7.99

Operating at more than one base station

kap17.fm5 Gig 2011 pocket, GBR PTT: A30852-X1101-B657-1-7619
Operating at more than one base station
You can register and operate your handset at up to 6 Gi-
gaset base stations (as of Gigaset 1010 and Gigaset 2010
and higher).
This offers the following advantages:
You can operate the same handset at base stations in
l
different geographical locations (e.g. in the office and at
home).
You can extend the range or the area in which you can
l
call with the same handset in large areas by placing
the base stations in suitable locations.
Please note the following when operating at
more than one base station:
Ongoing calls are interrupted or cleared
l
down when you move from one base sta-
tion radio range to another.
Internal calls can only be made within the ra-
l
dio range of a base station, i.e. not to hand-
sets that are in another base station radio
range.
You can extend the range of your base sta-
l
tion with Gigaset Repeater.
If you are out of range of a base station for
l
several minutes, and your handset is
switched on, then when you re-enter the
range it may take up to 20 minutes to "find"
the base station again. In such cases,
switch the mobile unit off for a minute and
then on again.
We recommend following the procedure below:
Register your handset at the required base stations
l
(' page 73) and assign the required base station num-
bers (1 to 6). Register your handset at all base sta-
tions with the same internal call number, provided this
is not yet assigned.
You can see which base station your handset is currently
using at any time on your handset display. Note the in-
structions for naming handsets on ' page 78.
79