Names And Functions Of Indications On Wireless Remote Controller; Preparation And Check Before Use; Sans Fil; Preparation Et Verification Avant Utilisation - Toshiba RAV-SM562KRT-E Owner's Manual

NAMES AND FUNCTIONS OF INDICATIONS ON WIRELESS
REMOTE CONTROLLER
Display
All indications, except for clock time indication, are indicated by pushing the START/STOP button.
1 Transmission mark 1 1
1 1
This transmission mark (,) indicates when the remote controller transmits signals to the indoor unit.
2 2 2 Mode display 2 2
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Dry, : Heat,
3 3 Temperature display 3
3 3
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
setting is indicated.
4 4
4 4 FAN speed display 4
Indicates the selected fan speed. AUTO or one of five fan speed levels
+
(LOW , LOW
HIGH
Indicates AUTO when the operating mode is either AUTO or
5 5
5 TIMER and clock time display 5 5
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER operation.
6 Hi POWER display 6 6 6 6
Indicates when the Hi POWER operation starts.
Push the Hi POWER button to start and push it again to stop the
operation.
7 ECO display 7 7
7 7
Indicates when the ECO (save energy) operation starts.
Push the ECO (save energy) button to start and push it again to
stop the operation.
8 8
8 8 8
(PRESET) display
Push another button to turn off the mark.
9 9 SLEEP TIMER display 9 9 9
Indicates when the SLEEP TIMER is in operation.
Each time you push the SLEEP button, the display changes in the sequence of 1, 3, 5 or 9h.

PREPARATION AND CHECK BEFORE USE

Loading the remote controller batteries.
1 1 Remove the cover, and insert the 1 1 1
batteries.
2 Push the RESET button. 2 2
2 2
The clock display flashes.
Adjust the clock.
Place back the cover.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep from the
indoor unit or when the air conditioner cannot be operated using
the remote controller.
• To avoid malfunctions by battery leakage, remove the batteries
when not using the remote controller for more than one month.
EN
: Fan only)
: Fan only, no temperature
, MED , MED
) can be indicated.
: Cool,
+
,
: Dry.
• Slide off the cover while
pressing the sides.
• Battery replacement
Be careful not to reverse the
(+) position and the (–)
position.
5
3 1 2
6 7
• In the illustration, all indications
are indicated for explanation.
During operation, only the
relevant indications will be
indicated on the remote controller.
9
2
8
4 5
1