Toshiba e-Studio 232 Operator's Manual page 260

6.Error Code (Cont.)
Scan Job
Error code
Remote Scan
2A20
2A40
2A50
2A51
Scan to E-mail
2C10, 2C12,
2C13, 2C20-
2C22
2C11, 2C62
2C14
2C15
2C30
8
2C31, 2C33
2C32
2C40
2C61
2C63, 2C64
2C65, 2C66,
2C69
2C6A
2C6B
258
8.JOB STATUS
Problem
System fatal error
Failed to acquire
resource
Job cancelling
Power failure
Illegal job status
Not enough memory
Invalid parameter
specified
Message size
exceeded limit or maxi-
mum size
Failed to create direc-
tory
Failed to create file
Failed to delete file
Failed to convert
image file format
Failed to read Address
book
Invalid domain
address
Failed to connect to
SMTP server
Failed to send E-mail
message
Invalid address speci-
fied in From: field
Perform the job in error again.
Turn the power OFF and then back ON.
Perform the job in error again.
Job was cancelled.
Check if the power cable is connected properly and it is inserted
securely. Check if the power voltage is unstable.
A system error has occurred during sending an E-mail. Retry it.
If the error still occurs, contact your service representative.
Scan job exceeded the limit or maximum size. Send your docu-
ments separately.
Make sure you specify the settings correctly and try again.
You are sending too many documents at a time. Send your doc-
uments separately.
Make sure that the access privilege to the storage directory is
writable and the server or local disk has a sufficient space. Then
retry the scan.
Make sure that the access privilege to the storage directory is
writable and the server or local disk has a sufficient space. Then
retry the scan.
Make sure that the access privilege to the storage directory is
writable and the server or local disk has a sufficient space. Then
retry the scan.
Turn the power OFF and then back ON.
Retry the scan. If the error still occurs, contact your service rep-
resentative.
Turn the power OFF and then back ON.
Retry the job in error. Reset the data in the Address book and
retry it. If the error still occurs, contact your service representa-
tive.
Ask your administrator to set the IP address.
Make sure the SMTP server is correctly working, or the SMTP
server address has been set correctly. Then retry the scan.
Turn the power OFF and then back ON. Retry the scan. If the
error still occurs, contact your service representative.
Ask your administrator to check if there is an illegal character in
the E-mail address of the equipment. Delete the illegal charac-
ter and reset the appropriate E-mail address, then perform the
job again.
What to do