Setting Of Correct Time - Lennox Compact Pro Installation Operating & Maintenance Manual

3.4.12
Use button T3 to select Night comfort Mode, which includes
Night Comfort
the following functions:
mode
- Gradual increase of the temperature set for coding.
- Gradual reduction of the temperature set for heating
(only HP models).
- Reduction of noise level.
- Lower energy consumption at night.
To select Night comfort mode press button T3 after selecting
the operating mode using button T4 and setting the
temperature using button T7. Ideally, you should start
night well-being mode operation just before you fall
asleep.
In cooling mode, the set temperature is held for one hour after
starting Night comfort mode operation. For the next hour, the
setting is allowed to increase gradually up to 2°C over the
original setting, while the fan speed setting is low.
After the second hour, the temperature and fan speed
settings are not changed.
In heating mode, the set temperature is held for one hour after
starting Night well-being mode operation. For the next hour the
setting is lowered gradually to 4°C below the original while the fan
speed setting is low. After the second hour, the temperature
and fan speed settings are not changed.
Night comfort mode operation is not available for
dehumidifying only.
Night comfort mode operation can be halted at any time
(ideally when you wake up in the morning) by pressing
button T3 again.
At this stage the temperature and fan speed settings made
prior to starting Night comfort mode operation go back into
effect.
3.4.13
The air conditioner logic provides the user with a choice
Setting programs
of two operating programs that can be set to start and
for operation
stop at programmed times, for example you might want the air
conditioner to start shortly before you return home so that it is
cool when you get there. To use these functions it is first
necessary to set the exact time on the remote control and then
set the time for the programs to start.
3.4.14
To set the exact time proceed as follows:
Setting of correct
a) Press button T6 Time and Program Setting, as many
time
times as necessary to display the hour indicator (H).
b) Press the toggle button T7 to increase or decrease
the numerical display until it shows the exact hour.
c) Press button T6 again to display the minute
indicator (M).
d) Press toggle button T7 to increase or decrease the
numerical display until it shows the exact time in minutes.
Fig. 37
Night well-being mode
Fig. 38

Setting of correct time