Resetting All Functions Of Remote Control; Maintenance; Cleaning Air Filter - Lennox Compact Pro Installation Operating & Maintenance Manual

3.4.17
Press button T10 to reset all the settings on the remote control.
Resetting all
This will cancel all the settings of the timer and the remote control
functions of
will use the default settings. In addition, by pressing T10 you will
remote control
display all possible indications so that you can verify the
proper conditions of the display.
3.4.18
If you lose the remote control unit, or the batteries are dead
Control of Air
or it is not working for any other reason, you can still control
Conditioner if
the air conditioner in the automatic mode using the
remote control
microswitch on the console, that is the same switch that has
is not available
to be used to reset the clogged filter alarm light.
To do this, proceed as follows:
- Make sure the red clogged filter alarm LED is not on.
If it is on, clean the filters and reset the indicator light as described
in paragraph 3.5.1 Cleaning of air filter.
- Use a sharp object to press the microswitch located under the
hole on the console.
- The air conditioner will function in "AUTO" mode.
To restore normal operation under the control of the remote control
unit, you need only give any command with the remote control unit
when it becomes available again.
3.5

MAINTENANCE

Your air conditioner has been designed to reduce
operations of routine maintenance to a minimum and
ensure that they can be performed easily by any user. The
only operations required are the three types of cleaning
illustrated below.
3.5.1
To ensure effective internal air filtration and satisfactory
Cleaning air
operation of your air conditioner, the air filter has to be
filter
cleaned periodically.
The need to perform this important operation is signalled after a
prolonged period of use by a red led lighting up on the control
panel (see fig. 26).
The filter is located on the front of the air intake grating on
the back of the machine.
To remove it, press on the two fastening hooks and pull the
filter toward you (see fig. 42). Wash the filter by forcing a
jet of water in the opposite direction from that of dust
accumulation.
In case of dirt that is hard to remove (such as grease or other
encrusted dirt) you may have to soak the filter first in a solution
of water and neutral detergent. Before replacing the filter
shake it to eliminate the wash water.
The last part of this operation consists of briefly pressing, with a
sharp object, the microkey located on the control panel.
The red led goes off and lights up again after the air
conditioner has been in operation for a few days.
Fig. 41

Resetting all functions of remote control

Fig. 42

Cleaning air filter