Lennox Compact Pro Installation Operating & Maintenance Manual page 25

The configuration of these selectors is seen on the ignition of the board; therefore it is
necessary to switch off and to switch on when you modify the disposition.
Find below the description of the function of each selector:
SELECTOR
A0-A8 Address board
CFG1
Brilliance Led
CFG2 Type of contact occupied room N.A.(norm. Open)
CFG3 Board model
1 The address of the board on CAN bus has to be unique and unequivocal; the coding is expressed on the
basis 2.
2 The function of this selector is active only for the configurated board that are not in mails; the brilliance
of the led for the boards in mails has to be determined through a specific command from the
reception.
3 Closed occupied room
4 Closed free room
EXAMPLES
Control board n° 321 (101000001) in
mains with contact room
N.C. (norm closed)
Control board nº 123 (001111011)
stand-alone with reduced brilliance
of the led and contact
N.A. (norm. open).
Stand-alone configuration.
FUNCTION 0
1
X
Normal
2
In mails
SELECTOR POSITION
1
X
Reduced
3
N.C.(norm. Cl o sed)
Stand-alone
4
1