Table of Contents
Advertisement
A; Pull the power cable, video
cable, RS485 and network cable
through wall mount bracket hole.
C; Pull the power cable, video
cable, RS485 and network cable
through back box feed through
hole and reserve a considerable
length.
Step 2
Connect cables
Connect power cable, video cable, RS485 and network
cable with the PCB board. Close hinged door and
screw firmly. Turn on the power, the indicate light is red.
Step 3
Install dome drive
a. Before installation, please take out the
protective foam and put it in a well place for
future use.
Note: when you ship the speed dome to the manufacturer, please insert these foams
to protect the drive.
b. Line up the red (A) and red (B) tabs with the red (A) and red (B) labels in the
interior cover. Push in (B) side and then the other side. Continue pushing on the
ends of the tabs until you hear a click noise.
B; Loosen the screws and then
open the hinged box.
D; Refer to the above figure, use
bolts to connect bracket and the
back box.
12
Advertisement
Table of Contents
