Videovox Pro C08 Operating Manual page 14

Open the hinged door to the back box.
Pull power cable, video cable, RS485 cable, network cable through cable feed out of
the conduit fittings. Connect them with PCB board.
Close the hinged door and screw the bolts.
Pushing the back box into the installation hole (you just cut in step 1) by
compressing the tab lock.
Tighten the screws in the black tab locks to fix the back box in the ceiling.
able
Steel safety c
Note: please install a safety chain/cable (not supplied) between the back box and the
ceiling to prevent network speed dome falling down!
Step 3
Install the dome drive.
Before installation, please take out the protective
foam and put it in a well place for future use.
Note: when you ship the network speed dome to the
manufacturer, please insert these foams to
protect the drive.
Line up the red (A) and red (B) tabs with the red
(A) and red (B) labels in the interior back box.
Push in (B) side and then the other side.
Continue pushing on the ends of the tabs until
you hear a click noise.
Red tab
Note: Please make sure the clips on both sides
are firmly fixed. You can follow the tab on the
outside cover to check.
10