Mounting The Turbo Elite - Specialized Turbo Elite Instruction Manual

the case with a coin.
FIGURE 3: BATTERY
INSTALLATION
MOUNTING THE
TURBO® ELITE:
The Turbo® Elite wireless
4 screws
CR2032 battery
Rubber O-ring
23A battery
Tightening
sequence
FIGURE 3
transmitter can mount on
the right or the left side of
the fork blade. The right
side should be used on
large frames or when a
suspension fork is installed.
The optimal distance
between the computer and
the transmitter is 24 inches
(610mm). The distance
may need to be less than
24 inches (610mm) if
4
ambient temperatures are
below 40 °F (4 °C). To
reduce signal loss in colder
temperatures, the transmit-
ter should be mounted as
close to the computer as
possible. (Maximum
mounting distance is 28
inches). Use the transmit-
ter-mounting shim and tie-
wraps provided to position
the sensor. Do not tighten
the tie-wraps until final
placement of the magnet is
correct. (See figure 4).
Wheel magnets have been
provided for both tradition-
al round spokes
and bladed
(flat) aerody-
20-28 in.
500-700mm
namic spokes.
For wheels with
round spokes:
Attach the
magnet to a
FIGURE 4
spoke across
from the transmitter with
the magnet screw. The
clearance between the
magnet and the transmitter
should be approximately
1/32"-1/16" (1-2mm).
Tighten the magnet and
transmitter. Do not over-
tighten the magnet screw.
(See figure 5).
For wheels with
bladed spokes:
Use some iso-
propyl (rub-
bing) alcohol or 1/32-1/16 in.
1-2mm
a mild deter-
gent to thor-
oughly clean
FIGURE 5
the spoke that
you plan to attach the
magnet to. Remove the
backing from the adhesive
tape and firmly press the
magnet onto spoke. The
tape uses a special pres-
sure sensitive adhesive. To
ensure a strong bond,
please wait at least 12
hours for the adhesive to
cure before riding your
bicycle.
Attach the appropriate
mount (26.0mm and
31.8mm sizes are includ-
ed) to the handlebar using
the bracket screw provided.
Tighten so that the bracket
cannot rotate on the han-
dlebar. There are several
sizing straps provided to fit
different diameter bars.
(See figure 6). Slide the
computer forward onto the
mount until it 'snaps' into
place with an audible
click. To remove the com-
puter, remove the cadence
FIGURE 6
wire (if connected) then
push it backward until it
releases from the mount.
To test for proper installa-
tion of the magnet, trans-
mitter and computer, acti-
vate the computer by push-
ing the 'MODE' (right side)
button. Pick up the front of
the bicycle and spin the
front wheel. The "wheel
option" indicator will flash.
If it does not flash, check
the sensor and magnet
alignment. Realign as nec-
essary until the "wheel
option" indicator flashes
while spinning the wheel
FIGURES 4,5 & 6
Mounting Cadence hard-
ware- In order to use the
5