Installing The Rear/Front Wheels - Joovy Caboose Stand-On Tandem Instruction Manual

Installing the Rear Wheels
Please use the following component sequence that
indicates how all the parts for the rear wheel assembly
are installed.
• Turn stroller upside down so that it rests on the
handlebar.
• Insert one end of the rear wheel axle through a rear
axle hole in the plastic bracket under the stand-on
platform.
• Push the axle across and into the axle hole on the
other side of the stroller.
NOTE: You may need to guide the axle into this
hole. Slide washers over each end of the axle.
• Place one rear wheel over one end of the axle. See
Figure 5.
NOTE: The brake teeth on the wheel should be
facing inward toward the red brake lever AND the
arrow shapes on the tire tread should point toward
the handlebar.
• Slide an additional washer over the end of the axle.
• Take one snap pin and insert the straight leg into
the small hole in the axle. Push it firmly into this
hole until the round portion of the other leg snaps
completely around the outside of the axle.
• Push the axle as far as it will go toward the opposite
side of the stoller, then repeat the installation steps
for the other wheel.
• Install a hubcap onto each wheel by aligning the 5
tabs on the hubcap with the 5 slots in the wheel,
and then pushing it into place. Ensure that ALL 5
snaps have engaged securely and the hubcap
cannot be pulled off.
Installing the Front Wheels
• Take one of the double wheel sets and locate the
small hole in the rotating bracket that is inside the
red lever.
• Push the front axle into this hole and keep pushing
the wheel set onto this axle until you hear an audible
click. See Figure 4.
• Pull downward on the wheel set to ensure that it
has locked into position on the axle. Also ensure
that both wheels rotate and roll smoothly.
• Repeat this same procedure for the other wheel set.
Caboose Ultralight Instruction Manual
ReAR WheeL SeqUeNCe
Step 1
Small Washer
Step 2
Rear Wheel
Step 3
Small Washer
Step 4
Snap Pin
Figure 4
Page 4