Seatback Positioning; Using The Stand-On Platform - Joovy Caboose Stand-On Tandem Instruction Manual

Seatback Positioning

The front seat has two positions. The fully upright
position should only be used for a child that is at
least 6 months old.
• To place the seat in the upright position, push
the bar on the rear of the seat toward the front of
the stroller and rotate the seatback towards the
front of the stroller until this bar is locked in its
LOWEST position. See Figure 20.
• To recline the seat, pull the bar on the rear of
the seat toward the rear of the stroller and rotate
the seatback down until this bar is again in its
LOWEST position.
Whether the seatback is upright or reclined, ALWAYS make certain
that the rotating bar behind the seatback is in its LOWeST position

Using the Stand-On Platform

• Push the bench seat to its most forward position.
• Position the canopy to its most forward position.
• Position the child on the platform on the back of the stroller. Be sure that the child is facing forward
and BOTH of their hands are holding the handles on the frame.
• Be sure that BOTH of the child's feet are fully on the platform at all times.
• You may need to adjust the position of the seatback to allow for more room for the child to stand.
The rear stand-on platform and the rear bench seat are designed for
a child that is at least 2-1/2 years old but LeSS than 44 inches tall and
Use of the stroller with two children weighing more than 45 pounds
each, or children totaling more than 90 pounds, will cause excessive
wear and stress on the stroller and may cause a hazardous unstable
NeVeR allow a standing child to use the canopy as a hand hold.
NeVeR use this stroller to carry more than 2 children at the same
Page 9
WARNING
!
before placing the child into the seat.
WARNING
!
less than 45 lbs.
condition.
Figure 20
time.
Caboose Ultralight Instruction Manual