Joovy Caboose Stand-On Tandem Instruction Manual page 6

Joovy caboose stand-on tandem 40x & 41x series
Table of Contents

Advertisement

Front Wheel Locks
The front wheels can be either in swivel mode or
locked mode.
• To put the front wheels in their locked mode, first
rotate each wheel set so that the wheels are pointed
straight ahead.
• Pull up on the lever to engage the small tab on the
lever with the slot in the plastic frame sleeve. The
lever can be either facing forward or rearward to
lock the wheels. See Figure 5.
• To unlock the wheels and put them into swivel
mode, push down on the lever to disengage the tab
from the slot.
Installing and Operating the Canopy
• To attach the canopy, position the canopy with the thick padded edge towards the front of the
stroller.
• Line up the male fittings on the canopy with the female fittings near the center of the stroller and push
downward until the fittings snap into place. See Figure 6. Pull upward on the canopy sides to be sure
both are snapped securely in place.
• To open the canopy, pull forward on the front edge of the canopy while holding the back edge in
place. Once the canopy is fully opened, push down on BOTH side hinges to lock it in the open
position.
• The canopy will ratchet forward or backward to block the sun. Pull forward on the front of the canopy
frame tube to rotate it forward. Pull backward on the rear frame tube to rotate it backward.
See Figure 7.
• To close the canopy, unlock the side hinges and pull the front edge toward the rear of the stroller until
folded. See Figure 8.
• To remove the canopy, press the lock button on the side of each of the male fittings while pulling
upward on the canopy frame. See Figure 9.
Figure 6
Page 5
Figure 5
Figure 7
Caboose Ultralight Instruction Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Caboose 40x seriesCaboose 41x series

Table of Contents