Parts List
Additional Accessories (sold separately)
Customize your ride with a number of optional accessories for added functionality. All accessories are sold separately.
Rain Cover
- Custom fit
- Vented
- All-weather protection
- Easy to install
Stroller Assembly
Please refer to the end of this manual for all photos that are referenced in parentheses in the instructions below.
Adult assembly is required for this product. No tools required.
Unfolding the Stroller
- Orient the stroller with the handle facing upward. Release the safety latch located on the left side of the stroller.(1)
- Pull upwards on the handle.(2) Keep pulling until the stroller is fully erected and the folding hinge on each side engages.
- Visually check and gently push downward on the handle to ensure that the stroller is completely opened and locked before ANY use of the product.
Keep children away from stroller while unfolding. ALWAYS ensure the folding mechanism on each side of the handlebar is fully engaged when the stroller is in the opened position. This action will prevent collapse of the stroller. Possible pinching hazard – Be careful when unfolding the stroller.
Installing/Removing the Front Wheels
- Slide one front wheel into the front wheel housing until it clicks into place.(3) Repeat for the other two wheels. Pull on the wheels to ensure they are installed properly.
- To remove, press the metal release button on the back of the front wheel housing and pull away from the stroller.(4)
Installing/Removing the Rear Wheels
- Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place.(5) Repeat for the other wheel. Pull on the wheels to ensure they are installed properly.
- To remove, push the release button on the rear wheel hub and pull the wheels from the stroller.(6)
Installing/Removing the Tray
- Remove the two safety caps from the seat mount points by pressing the release button and pulling each cap off. Store the safety caps in a safe place for future use.(7)
- To attach each tray, orient it with the male fittings pointed towards the seat.(8) Insert the male fittings on the tray into the female fittings located on both sides of the seat until they snap into place. Pull outward on the tray to ensure it is secure.
- To remove, press the buttons located on the underside of both female fittings inward and pull the tray away from the seat.(9)
- When using the stroller without the tray, always replace the safety caps.
For use ONLY on the Joovy Kooper RS2 Stroller. The tray is not a restraint device. ALWAYS secure your child with the restraint system. NEVER lift the stroller by the tray. Use caution when attaching the tray when there is a child seated in the stroller. The maximum weight that can be carried in each tray is 2 lbs. (0.9 kg).
Stroller Operation
Rear Wheel Brakes
- Always engage rear wheel brakes before placing a child in or removing a child from the stroller.
- To engage, push down on the brake lever.(10)
- To release, push down on the back of the brake lever.(11)
NOTE: Gently push the stroller back and forth to ensure the brake is fully engaged.
Always make sure the wheel brakes are engaged when the stroller is not being pushed so that the stroller will not roll away. Never leave stroller unattended, especially on a hill or incline, as the stroller may tip over or slide.
Securing the Seated Child
- There are three height adjustment positions for the shoulder harness. Adjust the height to the closest height above your child's shoulders.
- To remove the shoulder harness, turn the plastic ends sideways and push them through the slots in the backrest. Reattach the harness at the proper height by reinserting the plastic ends through the slots.(12) Ensure both straps are the same height.
- To unlatch the buckle, press the buttons on both sides and remove the male ends of each side. (13)
- Carefully place the child in the seat with the shoulder straps and pads over their shoulders and chest. Then place the crotch strap between the child's legs.
- Combine the shoulder/waist buckles together, then place the crotch buckle on top of the combined buckles until all parts are in place.(14)
- Tighten the waist belt to be snug around the child's waist.
- The shoulder, waist, and crotch straps may be adjusted using the sliding plastic rings.
The seats are not suitable for a child under 3 months. The maximum height of a child the product is designed to carry is 44 in (111.8 cm). The maximum weight of a child the product is designed to carry is 50 lbs. (22.7 kg) in each seat. Use of the stroller with a child weighing more than 50 lbs. (22.7 kg), or two children totaling more than 100 lbs (45.4 kg) will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition. Never leave child unattended. Avoid serious injury from falling or sliding out. Always use the restraint system.
Adjusting the Seat
- Each seat can be adjusted to any position from upright to fully reclined. To adjust, grasp the recline mechanism with one hand and the plastic D-ring on the strap with the other. Squeeze the recline mechanism and either push or pull to the desired position. (15)
ALWAYS make certain that the recline mechanism is engaged before placing the child in the seat, whether the seat is upright or reclined.
- To adjust the footrest, press the two buttons on both sides and place the footrest into the desired position. (16)
NEVER allow a child to step onto or sit on the footrest. This may cause the stroller to tip over and injure the child.
Canopy
- The canopy can be adjusted to be fully opened or closed.
- The canopy can be made larger by unzipping the extension zipper and pulling the canopy open.(17)
- The mesh window can be left opened or closed. Unfold the fabric flap on the back of the canopy for the opened position.(18) Fold the fabric flap over the mesh for the closed position.
Possible pinching hazard – Be careful when closing and opening the side hinges so as not to pinch your fingers.
Tray
- To use the tray's swing arm, release one side of the tray by pressing the release button and rotate the tray upward.(19)
- The tray insert is removable and dishwasher safe. To remove the tray insert, push the buttons on the tray frame and pull the tray side latch upward.(20)
- To attach the tray insert, fit the tray insert into the tray until both sides snap into place.
For use ONLY on the Joovy Kooper RS2 Stroller. The tray is not a restraint device. ALWAYS secure your child with the restraint system. NEVER lift the stroller by the tray. Use caution when attaching the tray when there is a child seated in the stroller. The maximum weight that can be carried in each tray is 2 lbs. (0.9 kg). This product is not a toy. DO NOT allow children to play with it.
Basket
- The storage basket should not be removed.
The maximum weight that can be carried in the storage basket is 22 lbs. (10 kg). Excessive weight may result in a hazardous unstable condition.
Folding the Stroller
- Keep children away from the stroller while folding.
- Rear wheel brake lever MUST be engaged before folding the stroller.
- Close both canopies.
- Push the secondary lock on the handle to the left and squeeze the button on the inside of the handle in.(21)
- Push the handle forward and slowly guide it towards the rear wheels.(22)
The stroller should automatically lock into place. (23) DO NOT force the stroller closed.
- Pull up on the handle to ensure the safety latch is secure.
While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
Rear wheel brakes MUST be engaged before folding the stroller. DO NOT force the stroller closed. ALWAYS keep children away from the stroller when folding. Possible pinching hazard – Be careful when folding the stroller.
Seat Fabric
- The seat fabric is removable for washing.
- Adjust the footrests to the upright position.
- Undo the snaps and Velcro® along the canopy apron.(24 and 25)
- Unfasten the seat fabric from the two pegs on the side seat panel.(26) Repeat for the other side.
- Release the strap from the metal D-ring on the folding hinge.(27) Repeat for the other side.
- Unfasten the seat fabric from the peg beneath the side of each seat.(28) Repeat for the other side.
- Release the strap from the plastic D-ring beneath each seat.(29)
- Undo the Velcro® beneath the footrests and pull the seat fabric free from the stroller frame.(30)
- Remove the shoulder and waist straps by turning the plastic ends sideways and pushing them through the slots in the seatback.(31 and 32)
- Remove the crotch strap by turning the plastic end sideways and pushing it through the slot in the fabric.(33)
- Open the zipper pocket at the back of each seat. Remove the plastic board.(34)
- Open the Velcro® pocket underneath each seat. Remove the plastic board. (35)
- The seat fabric is ready for washing.
- To reassemble, simply reverse the disassembly steps.
- Ensure all zippers, snaps, and straps are securely closed.
If you experience any of difficulty with the assembly or use of this product, or if you have a question regarding these instructions, please contact Team 432.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Need Assistance?
Do you have a question about the Kooper RS2 that isn't answered in the manual? Leave your question here.