4.2
Adjustments after Parts Replacement
Adjustments required after parts replacement are listed below.
Adjustment and correction of color deviations are always required after parts are replaced.
Part replaced
LED head
Drum cartridge (Y, M, C, B, and K)
Fuser Unit
Belt cassette assembly
EEPROM (PU block)
Oil Roller
Other parts
4.2.1
Confirm the LED head driving time
Note: The OKICOLOR 8/ OKIPAGE 8c Plus, if a new LED HEAD is placed, reads the contents
of EEPROM within the LED HEAD, automatically re-setting the drive time. Therefore, the
re-setting of drive time is unnecessary, but a confirmation to the drive time re-set is
necessary.
-
Display of illumination level of the LED head
41057601TH Rev.1
Correct color deviations.
Reset the drum counter and correct color deviations.
Reset the fuser counter and correct™™ color deviations.
Reset the belt counter and correct color deviations.
Correct color deviations.
Reset the oil roller counter.
Correct color deviations (if any).
405473
0 3 2 3 4 * * * * * * * * * 0 7 8 T H
The trailing three digits of this number
indicates the illumination level of the LED head.
Adjustment required
100/