3.3.25 Roller Registration, Roller Assy Hopping
1.
Remove the guide paper input assy. (See 3.3.23)
2.
Remove the bracket hopping motor. (See 3.3.19)
3.
Remove the gear one-way. (See 3.3.20)
4.
Remove the holder gear toner assy. (See 3.3.30)
[Removal of the roller registration]
Remove the gear 1 and 2 bushes 2 and 2 bearings 3, then 2 roller registrations 4.
5.
[Removal of the roller assy hopping]
Remove the bush 5 and the bearing 6.
6.
7.
Remove E-rings 9 of the sub-roller hopping at both sides of hopping roller and then release
the lock of the roller hopping 7 with the shaft 8 by spreading the claw, then remove the roller
hopping from the left side by sliding the shaft 8 in the arrow direction. (Be careful not to lose
the knock-pin for fastening the roller hopping 7, which slips off together.)
2
1 5
41057601TH Rev.1
Figure 3.3.25 Roller Registration, Roller Assy Hopping
3
6
9
4
8
9
7
72/