Quadra-Fire QFI30-C Owner's Manual page 36

LOG SUPPORT LOG SUPPORT
ANDIRONS ANDIRONS
OUTER TINES OUTER TINES
Figure 5.
Log #1 (SRV2225-701): Position the groove on the log with the right grate tine as shown in Figure 6. The opposite end of
the log will rest on the log support. Rotate the opposite end of the log clockwise until it contacts the refractory panel.
FLAT SPOTS FOR LOG #6 AND LOG #3 FLAT SPOTS FOR LOG #6 AND LOG #3
LOG CONTACTS LOG CONTACTS
LEFT REFRACTORY LEFT REFRACTORY
PANEL PANEL
MATE SLOT WITH MATE SLOT WITH
GRATE TINE GRATE TINE
Figure 7. Place Log #2
Log #2 (SRV2225-703): Mate the grate tine with the slot on the bottom of Log #2. The back end of the log rests on the log
support. The side of the log will contact the left refractory as shown in Figure 7.
POSITION LOG POSITION LOG
ON FLAT SPOT ON FLAT SPOT
3 3
LOG CONTACTS LEFT LOG CONTACTS LEFT
REFRACTORY PANEL REFRACTORY PANEL
LOG RESTS ON LOG RESTS ON
LOG SUPPORT LOG SUPPORT
Figure 9. Place Log #3
Log #3 (SRV2225-702): Position the left end of the log on the fl at spot of Log #2 as shown in Figure 7 and Figure 9. The
right end of the log rests on the log support and touches the back refractory. The left end of the log should contact the left
refractory panel.
Log #4 SRV(2225-705): Mate the slot on the bottom of Log #4 with the right log pin. Refer to Figure 11 for location of log
slot. Rotate the right end of the log clockwise until the groove on the end of the log mates with the grate bar.
36
LOG PINS LOG PINS
2 2
FLAT SPOT FLAT SPOT
FOR LOG #7 FOR LOG #7
LOG CONTACTS BACK LOG CONTACTS BACK
REFRACTORY PANEL REFRACTORY PANEL
Quadra-Fire • QFI30-C, QFI35-C • 2227-901 Rev. H • 7/12
LOG RESTS ON LOG RESTS ON
LOG SUPPORT LOG SUPPORT
Figure 6. Location of Log #1
SLOT SLOT
Figure 8. Slot on Log #2
MATE LOG MATE LOG
PIN WITH PIN WITH
LOG SLOT LOG SLOT
MATE GRATE BAR MATE GRATE BAR
WITH LOG GROOVE WITH LOG GROOVE
Figure 10. Place Log #4
LOG GROOVE LOG GROOVE
CONTACTS CONTACTS
1 1
GRATE TINE GRATE TINE
4 4