Quadra-Fire QFI30-C Owner's Manual page 33

FLAT SPOT FOR LOG #5 FLAT SPOT FOR LOG #5
1 1
LOG CORNER ALIGNS LOG CORNER ALIGNS
WITH LOG TAB WITH LOG TAB
NOTCH MATES WITH LEFT NOTCH MATES WITH LEFT
GRATE TINE GRATE TINE
Figure 6. Placement of Log #1
Log #1 (SRV2227-703): Mate the notch located on the bottom of the log, with the left grate tine. See Figure 7. Bend the
tab located to the left of the pilot assembly into the vertical position. Rotate the back end of log clockwise until it contacts
the log tab as shown in Figure 6.
LOG CONTACTS REFRACTORY LOG CONTACTS REFRACTORY
LOG CONTACTS LOG CONTACTS
LOG SUPPORT LOG SUPPORT
LOG RESTS ON BURNER LOG RESTS ON BURNER
Figure 8. Place Log #2
Log #2 (SRV2227-702): Rest left end of log on the fl at spot of Log 1. See Figure 6 and Figure 8. The left end of the log
should touch the left refractory panel. The right end rests on the burner. Push the right end back, until it touches the edge
of the log support.
Log #3 (SRV2227-701): Mate the notch with the right grate tine as shown in Fig 9. The back of the log should rest on the
log support as shown. Rotate the back end of the log clockwise until it contacts the right refractory panel.
LOG GROOVE LOG GROOVE
LOG PIN LOG PIN
(FOR LOG #6) (FOR LOG #6)
MATES MATES
WITH SLOT WITH SLOT
4 4
MATE NOTCH MATE NOTCH
WITH GRATE BAR WITH GRATE BAR
Figure 10. Log #4
FLAT SPOT FOR LOG #2 FLAT SPOT FOR LOG #2
2 2
Quadra-Fire • QFI30-C, QFI35-C • 2227-901 Rev. H • 7/12
Figure 7. Location of Notch on Log #1
LOG RESTS ON LOG RESTS ON
REFRACTORY SUPPORT REFRACTORY SUPPORT
NOTCH MATES WITH NOTCH MATES WITH
RIGHT GRATE TINE RIGHT GRATE TINE
Figure 9. Log #3
Figure 11. Log #4
NOTCH NOTCH
LOG GROOVE LOG GROOVE
(FOR LOG #6) (FOR LOG #6)
3 3
NOTCH NOTCH
33